Technical Data; Troubleshooting - AEG DVD 4506 Bedienungsanleitung

Technical Data

Power supply:
Power consumption:
Signal System:
Operating temperature range: +5~+35°C
Operating humidity range:
Compatible Disc Formats:
1. DVD video disc • 12cm single-sided, single-layer
• 12cm single-sided, double-layer
• 12cm double-sided, double-layer
• 8cm single-sided, single-layer
• 8cm single-sided, double-layer
• 8cm double-sided, double-layer
2. CD Disc • 12cm disc
• 8cm disc
Video Output:
• Output level:1 +/- 0.2Vp-p(75 ohm)
• Horizontal resolution: >450 blinds
• Signal-to-noise ratio: >60dB
Analogue Audio Output (Impedance: 10k ohm)
• Output level: 1.8+0.2/-0.8Vrms
(1KHz 0dB)
• THD: <0.01% (JIS-A 1KHz, typical)
• Dynamic range: >80 dB
(JIS-A 1KHz, typical)
• Signal-to-noise ration: >100 dB
(JIS-A 1KHz, typical)
Digital Audio Output:
• Coaxial output and optical output
Data relating to weight and dimensions are approxima-
te values. Errors and omissions accepted. Subject to
design and technical modifi cations.
5....-05-DVD 4506 AEG GB 23
AC 230V ~50Hz
25W
PAL/NTSC
5~90% (no condensation)

Troubleshooting

If faults occur during operation of the device, you should
fi rst check the table below before contacting your
specialist dealer or our customer service department.
In the case of technical defects, the device may only be
repaired by range specialists.
Problem Possible Solution
No power • Check whether the mains plug is
correctly connected.
• Switch the device off and on again.
Cannot read disc • The player needs up to 10 seconds to
read in DVDs.
• For MP3, WMA and JPEG discs up to
15 seconds are required.
• The disc is scratched or bent and must
not be used any more.
No picture • Check the cable connections and the
connection settings (see section on
„Connections").
• The AV settings must correspond to the
video output format.
Picture too dark If you have connected a scart cable
you must not connect any other video
cable at the same time (see section on
„Connections").
Picture interference The wrong television standard has been
selected (NTSC instead of PAL).
No sound • Check the cable connections and the
connection settings (see section on
„Connections").
• Ensure that the sound has not been
switched off.
When an optical Check the following settings:
or coaxial cable is a) For SPDIF OUTPUT the OFF setting
used no sound is must have been selected.
produced. b) When a stereo system was connected
an incorrect setting was selected.
Player does not • Check whether the batteries have been
react to the remote inserted the right way round.
control • Replace old batteries. Point the remote
control directly at the reception sensor
on the player.
Unit does not react Switch the player off and then on again. If
to key input or there this does not rectify the problem, the unit
is picture or sound should be disconnected from the mains
interference. power supply for 10 minutes.
Forgotten password Stop playback and call up the setup
mode. Enter the password 8888. This will
switch off the child protection.
Static electrical fi elds or other external interference may
adversely affect the operation of the device. In such
cases please switch the device off and remove the plug
from the socket before switching it on again.
23
22.04.2004, 11:29:24 Uhr