This product may only be charged with the mains adapter (model
no.: SD-G0900500D) or car adapter (model no: YL003) provided.
Please be aware that while the mains adapter or the car adapter
is plugged in, it uses a small amount of power, even when the
product is not switched on. Unplug the mains adapter or the car
adapter from the socket to stop using it.
The mains adapter
suitable for use with the product.
The illuminant is not replaceable.
If the illuminant fails at the end of its life, the entire product must
be replaced.
Before use
Charging the product
Note: You can charge the product from an ordinary domestic mains
power outlet or from the cigarette lighter socket in your vehicle.
Tip: We recommend that you charge the product from an ordinary
domestic mains power outlet to avoid draining your vehicle's battery.
CAUTION! Do not connect the product to the cigarette lighter socket
of your vehicle if the vehicle battery is old or degraded. Failure to
observe this advice may result in your vehicle's engine not starting.
Note: To use the product without an adapter, you must first charge the
integral rechargeable batteries. It takes 5–7 hours to charge the inte-
gral batteries. The rechargeable batteries are permanently installed
in the handle of the product.
Note: Charge the product for approximately 12 hours before first use.
Note: Charge the product at least once a month, if it is to remain
unused for an extended period of time.
Note: If the product has not been charged for an extended period
of time (approx. 2 months), you could find that the integral recharge-
able batteries have entered a dormant state. Charge and discharge
the product a number of times in succession to reactivate the integral
rechargeable batteries.
Switch off the product during the charging process (set the
ON / OFF switch
Remove the rubber protection cap
product.
Insert the power output connection plug of the mains adapter
or the car adapter
in the handle of the product.
Note: During charging from a cigarette lighter socket, ensure
that the car adapter is always completely inserted into the ciga-
rette lighter socket of the vehicle. Failure to observe this advice
may result in risk of fire from overheating.
Insert the mains adapter
adapter
4
Note: The product has an overcharging protection system.
Nevertheless, you should disconnect the product from the mains
once the charging process is complete.
Note: The LED charging indicator
charging process. When the charging process is complete, the
LED charging indicator
charging indicator
out of the mains socket or the car adapter
3
rette lighter socket. Disconnect the mains adapter or the car
adapter from the product to prevent the batteries from discharg-
ing themselves.
Place the rubber protection cap
connection socket
8
GB/IE/NI
and car adapter
3
to position 0).
5
into the power input connection socket
4
3
into the cigarette lighter socket of your vehicle.
illuminates green. When the LED
2
illuminates green, pull the mains adapter
2
before you start to use the product again.
6
provided are only
4
from the bottom of the
8
into a mains socket or the car
illuminates red during the
2
back on the power input
8
3
6
out of the ciga-
4