TOHATSU MFS 5C LPG Benutzerhandbuch Seite 23

can cause serious burn or, if it comes in
contact with your eye, loss of sight. Use
safety glasses and rubber gloves.
In case battery electrolyte comes in contact
with:
Skin, flush thoroughly with water.
Eye, flush thoroughly with water, and then
seek immediate medical treatment.
In case battery electrolyte is swallowed:
Seek immediate medical treatment.
ENOW00013-B
WARNING
Battery generates explosive hydrogen gas.
Be sure to:
Charge the battery in a well-ventilated
place.
Place the battery away from any source of
fire, sparks and open flames such as
burners or welding equipment.
Do not charge the battery when the elec-
trolyte level is low. Otherwise, the bat-
ter y will be damage d and may cause
malfunction.
ENOW00014-0
CAUTION
Make sure that the battery leads do not
get stuck between the outboard motor
and boat when turning, etc.
The starter motor may fail to operate if
the leads are incorrectly connected.
Be sure to correctly connect the (+) and
(—) leads. If not, the charging system will
be damaged.
Do not disconnect the battery leads from
battery while the engine is operating, the
electrical parts could be damaged.
Always use a fully charged battery.
ENOW00015-0
CAUTION
Do not use a batter y that is not recom-
mended. Use of a battery not recommended
can lead to poor performance of, and/or
damage to, the electrical system.
ENON00006-A
Note
Recommended battery: 12V 40AH/5HR,
350 (Cold Cranking Amps (CCA), In case of
cold whether: 12V 70AH/5HR (650CCA))
Specifications and features of batteries
vary among the manufacturers. Consult
the manufacturer for details.
* The battery should be purchased sepa-
rately and is not supplied with the out-
board motor.
1. Connect the battery cable to the
leads that come from the bottom
cowl.
2. Place the battery box in a convenient
position away from possible water
spray. Securely fasten both the box
and the battery so they do not shake
loose.
3. Connect the positive lead (+) to the
positive terminal (+) of the battery,
and then connect the negative lead
(—). When disconnecting the battery
always remove the negative lead (—)
first. After connecting the positive
terminal (+), securely place a cap on it
to prevent short circuits.
1
+
2
-
1. Battery cord (red)
2. Battery cord (black)
21
INSTALLATION
5
ENOF01508-0