Panasonic AG-DV2500E Bedienungsanleitung Seite 34

RECORDING
Setting
NTSC indicator
POWER
A.DUB
AG-DV2500
CH
MIC REMOTE INPUT
OFF LINE
9PIN WIRELESS DV S-VIDEO
INPUT switch
Memo
•
For DV signal input, the sig-
nal system (NTSC/PAL) is
identified automatically.
•
For DV signal input, the AU-
DIO MODE item cannot be
set. It will be the same mode
as that of the input signal.
(48K/44.1K/32K)
AUDIO/VIDEO menu
– – – A U D I O V I D E O – – –
A U D I O MO D E 4 8 K
A O U T A T S E A R C H O N
A U D I O O U T S E L C H - 1 / 2
A U D I O OU T L E V N O RM
S E T U P ( N T S C ) O F F
P A G E B A C K
SYSTEM menu
– – – S Y S T E M – – –
S T I L L MO D E F I E L D
S E R I E S R E C T I M E O F F
S T I L L T I M E R 5 M I N
P A U S E P R O T E C T F . A D V
I N D E X W R I T E O N
D C I N MO D E P OW E R O F F
P A G E B A C K
E-34
PAL indicator
REC
DVCAM NTSC PAL REC INH.
1 / 3
REW
2 / 4
AUDIO
Setting the signal system (NTSC/PAL)
The signal system for analogue input is set with the NTSC/PAL
switch located at the rear panel. Either the NTSC or the PAL indica-
tor on the front lights up, depending on the setting.
* Before setting the NTSC/PAL switch, please set the unit to the
POWER OFF mode.
Selecting the video input signal
Please use the INPUT switch on the front panel.
S-VIDEO
LINE
DV
Setting the AUDIO/VIDEO menu (
• AUDIO MODE
Use this menu item to set the audio sampling frequency for recording.
32K : Perform recording with an audio sampling frequency of 32kHz.
Use this setting when performing audio dubbing on CH3 and
CH4.
48K : Perform recording with an audio sampling frequency of 48kHz.
Audio dubbing is not available.
• SET UP (NTSC only)
During recording
During playback
* A high level of knowledge pertaining to video signals is necessary
to set this menu.
Generally, SETUP OFF is used.(
Setting the SYSTEM menu ( ☞ Page 55)
• INDEX WRITE
This setting turns on/off automatic recording of index signals when
recording begins.
Setting the time code recording during DV signal input
Set the DV TC DUP. item of the TIME CODE menu to determine
whether to use the time code from the built in time code generator or
the data from the DV terminal. (
– Connection and setting –
NG :
SHOCK HAZARD - DO NOT OPEN.
EJECT
ISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR.
N/OUT
MENU
PLAY PAUSE DIO
SET
FF
STOP
CH 2/4
: Input Y/C separate video signals.
: Input composite video signals.
: Input DV signals.
: Selects whether to use setup on the input com
posite and Y/C separate signals.
: Selects whether to apply setup to the compos-
ite and Y/C signals.
Rear panel
VIDEO
I
N
9PIN REMOTE
O
U
T
S -VIDEO
LINE
NTSC/PAL switch
☞
Page 57)
☞
page 57)
☞
Page 58)
DC 12V
NTSC PAL
AUX