Clean Pump Pedestal; Storage; Waste Disposal And Environmental Protection - FLORABEST FTP 400 D3 Originalbetriebsanleitung

GB IE
1. Unscrew the adapter with the
hose connection (10) on the
angle adapter (12) and remove
the backflow stop (11a) and seal
(11b).
2. Insert the seal (11b) into the
back flow stop (11a).
3. Set the backflow stop (11) be-
tween the angle adapter (12)
and the adapter with the hose
connection (10) in such a man-
ner that the stop is opened in
the flowing direction and closed
against the flowing direction.

Clean pump pedestal

Always remove the mains plug be-
fore working on the device.
Moving parts create the risk of elec-
trocution or injury.
Dirt on the underside of the pump can be
removed after removing the cover plate
(4b) on the pump pedestal (4):
1. Loosen the 4 screws (4a) on the
underside of the pump pedestal
(4) and remove the cover (4b).
2. Remove the dirt from the under-
side of the pump with running
water. Do not use your fingers.
3. Screw the cover plate (4b) back
on.
Any measures above and beyond these, par-
ticularly opening the equipment, are to be
carried out by an electrician. In the case of
repairs, always contact our service centre.
12

Storage

• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Hand the tool in at a recycling centre. The
plastics and metal parts can be separated
and recycled. Ask your Service Center
about this. Defective units returned to us
will be disposed of for free.