Clean Pump Pedestal; Storage; Waste Disposal And Environmental Protection - FLORABEST FTP 400 D3 Originalbetriebsanleitung

1. Unscrew the hose adaptor (10)
on the angle adaptor (12) and
remove the backflow stop (11a)
and seal (11b).
2. Insert the seal (11b) into the
back flow stop (11a).
3. Set the backflow stop (11) be-
tween the angle adaptor (12)
and the
such a manner that the stop is
opened in the flowing direction
and closed against the flowing
direction.

Clean pump pedestal

Always remove the mains plug be-
fore working on the device.
Moving parts create the risk of elec-
trocution or injury.
Dirt on the underside of the pump can be
removed after removing the cover plate
(4b) on the pump pedestal (4):
1. Loosen the 4 screws (4a) on the
underside of the pump pedestal
(4) and remove the cover (4b).
2. Remove the dirt from the under-
side of the pump with running
water. Do not use your fingers.
3. Screw the cover plate (4b) back
on.
Any measures above and beyond these,
particularly opening the equipment, are
to be carried out by an electrician. In the
case of repairs, always contact our service
centre.
hose adaptor (10) in

Storage

• Clean the pump before storage.
• Store the appliance in a dry, frost-free
place, and where children cannot gain
access to it.
• When the pump is not to be used for
a longer period, it must be thoroughly
cleaned after its last use, and before it
is next used. Otherwise there may be
problems in starting the pump, caused
by deposits and residues.
Waste Disposal and En-
vironmental Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them.
Electric appliances should not be
disposed of in the domestic gar-
bage.
Hand the tool in at a recycling centre. The
plastics and metal parts can be separated
and recycled. Ask your Service Center
about this. Defective units returned to us
will be disposed of for free.
GB
13