Troubleshooting - Triton TSPSP 650 Gebrauchs- Und Sicherheitsanweisung

Troubleshooting

Problem
No function when ON/OFF Switch (2) is operated
Motor suffers from cut-outs, loss of performance and
produces sparks and/or burning smells
No sanding action when ON/OFF Switch (2) is operated,
despite the motor running
Slow material removal
Scratches on workpiece after sanding
Burn marks on workpiece
Excessive dust emission
GB
10
Possible cause
No power
Defective ON/OFF Switch
Carbon brushes worn
Gears not engaged
Sanding Sleeve (9) too fine or worn
Tool speed set too low
Sanding Sleeve too coarse
Not enough material removed
Sanding Sleeve incompatible with material
Tool speed set too high
Too much pressure exerted on to the sander
Vacuum dust extraction system not connected, or extraction
system not switched on
Dust extraction not working; dust extraction blocked
Solution
Check power supply
Have the ON/OFF Switch replaced by an authorised
Triton service centre
Have the brushes replaced by an authorised
Triton service centre
Consult a Triton service centre
Fit new Sanding Sleeve with coarser grit
Increase tool speed
Fit new Sanding Sleeve with finer grit
Continue sanding
Fit correct Sanding Sleeve
Decrease tool speed
Use less pressure whilst moving the machine
Check connection of the vacuum hose, the Dust Extraction
Port Adaptor (7) (if used) and ensure dust extraction system
is switched on
Check dust extraction system; unblock dust extraction
(see 'Cleaning the dust extraction port'.) Consult a Triton
service centre if problems persist