Familiarisation
1. Temperature control
2. Slide-out drawer
3. Slide-out drawer
4. Adjustable feet
Before using for the first time
–
Remove any exterior and interior packaging materials completely, including the adhesive strips.
Before it is connected to the mains, the unit must be thoroughly checked for transport damage,
including its power cord.
Clean the unit as described in the section De-frosting and cleaning.
To ensure proper functioning, wait for about two hours before connecting the unit and switching
it on after it has been positioned.
When the unit is first switched on, a slight 'new' smell may be noticed. However, this will
disappear once the cooling process has begun.
Installation
The appliance should be set up in a well-ventilated, dry room.
It should be operated in conditions where the relative humidity is no more than 70 %.
The product data sheet contains details of the ambient temperature range suitable for this
appliance.
Do not use the appliance outdoors. Ensure that the plug is accessible and can be removed from the
wall socket at any time.
Do not expose the appliance to direct sunlight, and do not position it next to any heat sources
(radiators, cookers etc). If this cannot be avoided, however, suitable insulation must be in installed
between the heat source and the unit.
The unit must not be installed inside a cupboard; when positioning the unit, also ensure that it is not
placed directly underneath a shelf or any other similar object.
Ensure that there is sufficient space in front for the door to open to 160°.
In the case of uneven floors, the adjustable feet at the front can be used to compensate and ensure
optimum stability.
Ventilation
Ensure that there is enough space around the unit so that the air circulation round and behind it is not
obstructed. (rear and sides 5 cm, top 10 cm.)
Reversible door
The design provides for the door to be reversed, i.e. for right-hinged (default installation) to become
left-hinged.
14