Yamaha RX-V3800 Bedienungsanleitung Seite 42

Optimizing the speaker setting for your listening room (YPAO)
6
Once you have selected the desired settings
of each parameter, press 4 l to return to the
previous menu level and then press 4 n to
select "Start".
7
After the setting of the measurement, start
the automatic setup procedure.
Refer to steps 4 to 6 of "Basic procedure of the
automatic setup" on page 37 for details.
System Memory feature
You can save multiple result of the automatic setup by using
the System Memory feature. See page 98 for details.
Reviewing the result of the automatic
setup
Use this feature to review the result of the automatic setup.
Set the operation mode selector to D AMP
1
and then press G SET MENU to turn on the
GUI screen.
2
Press 4k / n repeatedly and then 4h to
select "Auto Setup".
Input Select
Manual Setup
Auto Setup
System Memory
Signal Info.
3
Press 4k to select "Information".
Information
Setup Menu
Start
4
Press 4h and then 4n repeatedly to select
the desired check items.
Wiring
Distance
Size
40
En
Information
Setup Menu
Start
Wiring
Distance
Size
Left Right
Front NRM NRM
Center NRM
Sur. NRM NRM
S.Back NRM NRM
PRNS NRM NRM
SubWfr NRM
Reload:ENTER
Wiring (Speaker wiring)
Displays the polarity of each connected speaker.
• "NRM" appears when the polarity of the connected
speaker is normal.
• "REV" appears when the polarity of the connected
speaker is reversed.
Note
"–––" appears when no speaker is connected to the
corresponding speaker channel.
Distance (Speaker distance)
Displays the speaker distance from the listening
position. Press 4l / h to switch the unit to display
the value of the each speaker distance.
Note
"–––" appears when no speaker is connected to the
corresponding speaker channel.
Size (Speaker size)
Displays the size of the connected speakers. The bass
cross over frequency ("Cross") appears at the bottom
of the menu area.
• "LRG" appears when the connected speaker has
the ability to reproduce the low-frequency signals
effectively.
• "SML" appears when the connected speaker does
not have the ability to reproduce the low-frequency
signals effectively.
Note
"–––" appears when no speaker is connected to the
corresponding speaker channel.
Equalizing (Speaker equalizing)
Displays the result of the adjustment of the frequency
responses of each connected speaker.
Note
"–––" appears when no speaker is connected to the
corresponding speaker channel.
Level (Speaker level)
Displays the speaker output level of the connected
speakers.
Note
"–––" appears when no speaker is connected to the
corresponding speaker channel.