Playback; Basic Procedure - Yamaha RX-V3900 Bedienungsanleitung

Caution
Extreme caution should be exercised when you play
back CDs encoded in DTS. If you play back a CD
encoded in DTS on a DTS-incompatible CD player,
you will only hear some unwanted noise that may
damage your speakers. Check whether your CD player
supports CDs encoded in DTS. Also, check the sound
output level of your CD player before you play back a
CD encoded in DTS.
y
To play DTS-encoded CDs when using a digital audio
connection, set "Decoder Mode" in "Input Select" to "DTS"
before the playback (page 74).
Before performing the following operations, set the operation
mode selector on the remote control to F AMP.

Basic procedure

1
Turn on the video monitor connected to this
unit.
y
• If you connect two video monitors to the HDMI OUT
jacks of this unit, press RHDMI OUT repeatedly to select
the active video monitor(s). See page 37 for details.
• You can operate this unit by using the graphical user
interface (GUI) screen (page 65).
• You can configure the display settings with "Video"
(page 82) and "Display Set" (page 87).
Rotate the C INPUT selector (or press one
2
of the input selector buttons (3))
The name of the selected input source appears for a
few seconds.
Available input sources
USB DOCK V-AUX VCR DVR CBL/SAT
NET
36
En

Playback

DVD BD/HD DVD MD/CD-R TV CD PHONO MULTI CH TUNER
D V D
Selected input source
3
Start playback on the selected source
component or select a broadcast station.
• Refer to the instruction manuals for the source
component.
• FM/AM radio tuning (page 48)
• Bluetooth component playback (page 54)
• iPod playback (page 56)
• Playback via USB or network (page 58)
Rotate P VOLUME (or press J VOLUME +/–)
4
to adjust the volume to the desired output
level.
y
To adjust the level of each speaker, see page 47.
Rotate the M PROGRAM selector (or press
5
one of the sound field program selector
buttons (Q) repeatedly) to select the desired
sound field program.
For details about sound field program, see page 40.
Selected sound field program category
Selected sound field program
y
To switch the information (current input source, current
sound field program, etc) displayed in the front panel
display, press KINFO (or set the operation mode selector
to FAMP and then press CINFO) repeatedly.
M o v i e
S c i - F i