Operation; Maintenance - Husqvarna DT600 Bedienungsanleitung

3. Press the right moss dethatcher (C) onto the right
drive shaft from the gear housing (E).
To start the product with a cold engine
If you have a gasoline operated product, obey these
instructions to start the product with a cold engine.
1. Run the basic product warm and then shut down the
product.
2. Mount the attachment as per the assembly
instructions.
3. When adjusting the carburettor, make sure that the
dethatcher is held against the ground and that no
one else is in the vicinity.
4. Keep the moss dethatcher idling.
5. Make sure that the handle and safety features are in
good working order. Never use a product that lacks a
part or has been modified outside its specifications.
To use the attachment
1. Run the moss dethatcher at full gas (or nearly full
gas) with the wheels resting on the surface.
Introduction
Below you will find some general maintenance
instructions. If you need further information please
contact your service workshop.
To perform maintenance on the
attachment
CAUTION: Much work on the moss
dethatcher is often done in dusty conditions.
If you have a gasoline operated product, it is
extremely important that the air filter is
232
C
E

Operation

Maintenance

4. Fasten the moss dethatcher roller with split pin (B)
into the inner hole in the shaft.
A
5. Mount the splash guard with the snap-on fasteners
(D).
Note: For assembling accessories on basic product,
refer to the manual of the basic product.
Note: It is both tiring and unnecessary to lift or hold
the moss dethatcher above the surface when
working.
2. Keep an acute working angle to the surface. With a
large working angle, the moss dethatcher tends to
move towards you and you risk losing control of the
product.
inspected regularly, often daily, and oiled in
order to work satisfactorily.
Refer to the operator's manual of the power
unit for maintenance instructions.
WARNING: Always wear protective gloves
when you perform maintenance on the
attachment.
B
C
743 - 002 -