GB
* Settings
2.
or
3. Select the required menu item with
and accept with
4. Make the settings.
Note: The menu items are described in the
following sections.
5. Return to the main menu with
NOTE Further menu items: see chapter
5.2 "Making the basic settings", page 50.
7.2
Activating/deactivating the button tones
* Key clicks
1.
or
2. Activating/deactivating the button tones:
■
Activate
or
Activate the button tones.
■
Deactivate
or
Deactivate the button tones.
7.3
Activating/deactivating Eco mode
(Robolinho 700/1200/2000)
In Eco mode, the appliance switches to energy-
saving mode. This reduces the energy consump-
tion and noise emissions.
NOTE With high and thick grass and for
thick rolled turf, this is not recommended or may
not be possible.
* EcoMode
1.
or
2. Activating/deactivating Eco mode:
■
Activate
Activate Eco mode.
■
Deactivate
Deactivate Eco mode.
7.4
Setting the rain sensor (Robolinho
700/1200/2000)
NOTE Mowing when the grass is dry re-
duces soiling. By activating the rain sensor and
setting a delay time, it is possible to prevent the
appliance mowing when the grass is wet.
If the rain sensor is activated, the appliance
moves back into the base station when the rain
begins. It remains there until the rain sensor has
dried. Then it waits for the time period that is set
as the delay before it continues mowing. The
sensitivity of the rain sensor is adjustable.
52
or
.
.
:
:
:
:
* Rain sensor
1.
or
2. Activating/deactivating the rain sensor:
■
Activate
or
Activate the rain sensor.
■
Deactivate
or
Deactivate the rain sensor.
3. Setting the delay of the rain sensor:
■
* After rain delay
or
■
xx hours xx minutes
Select the required value for the delay
with
or
4. Setting the sensitivity of the rain sensor:
■
* Rain sensitive
or
■
Select the required value for the sensitivi-
ty with
or
7.5
Setting the mowing program
7.5.1
Setting the mowing program – General
1. Call up the main menu with
* Programs
2.
or
3. Select the menu item with
cept with
.
4. Carry out the settings.
Note: The menu items are described in the
following sections.
7.5.2
Setting the start points
Teaching-in start points
1. Place the appliance in the base station.
2. Switch on the appliance with
3. Call up the main menu with
* Programs
4.
or
* Entry Point
5.
or
* Interactive teach
6.
or
* Start interactive entry
7.
or
point teaching
■
Start
or
moves along the boundary cable.
■
Set
or
has reached the required start point. The
start point is stored.
Settings
:
:
and accept with
and accept with
.
or
and ac-
.
.
:
. The appliance
when the appliance
Robolinho
.
.