Trouble Shooting; Fault Correction - Parkside PNTS 1300 E4 Originalbetriebsanleitung

Trouble shooting

Problem
Device does not start
Low or lack of suction
Float does not switch
the appliance off
Dust or dirt is blow
out of the device
Possible cause
Mains voltage is not present
Defective on/off switch
(
3)
Worn carbon brushes
Defective motor
Hose system (
13/14) or
jets (
18/20) blocked
Suction pipe (
12) assem-
bled incorrectly
Container (
6) open
Container (
6) full
Filter (
15/16/17) full or
clogged
Float in ilter basket (
incorrectly positioned (e.g.
due to jerky movements)
Float in the ilter basket
(
21) faulty
Float in the ilter basket
(
21) does not move
Float in the ilter basket
(
21) faulty
Filter (
15/16/17) is not
or not correctly assembled
GB

Fault correction

Check plug socket, cable, line,
plug and fuse, where appropri-
ate, repair through electrical
specialist
Repair through customer service
Remove obstructions and block-
ages
Assemble suction pipe correctly
Close container
Empty container
Empty, clean or replace ilter
21)
Switch off the equipment so the
ball drops then switch on again
Repair by Customer Care
Release loat
Repair by Customer Care
Use missing ilters or check the
correct position of the ilter
IE NI CY
13