Blow Function; Filter Cleaning Button; Cleaning/Maintenance; Cleaning & Maintenance - Parkside PNTS 1400 H4 Gebrauchsanweisung, Originalbetriebsanleitung

2. Suctioning up (draining) water: place
the suction hose (
( 20) into the water tank and suction
up the water.
3. Empty the stainless steel container
immediately after suction cleaning be-
cause it is not designed to store liquids
(see „Cleaning/Maintenance").
Never reach into the water to
be suctioned up. Danger of
electric shock.
When the container (
the suction opening is shut off by
a float, and suction is then cut off.
Switch the appliance off, remove
the plug from the socket and empty
the container (see "Cleaning/Main-
tenance").
If foam or liquid exits, switch off the
machine immediately.

Blow function

Operation without the use of a filter
is recommended.
• Connect the suction hose (19) to the
connecting blower (15) on the motor
head (3).

Filter cleaning button

Insert the mains plug of the device
and turn the device on.
If the suction power decreases, you can
improve it by pressing the filter cleaning
button ( 28).
19) on the handle
9) is full,
1. Turn the device on.
2. Close the suction opening of the suc-
tion hose by hand.
3. Press the filter cleaning button (

Cleaning/Maintenance

Pull out the mains plug.
Danger of electric shock.
Always check the appliance before
use for any obvious faults such as
a defective mains cable, and have
these repaired or replaced.

Cleaning the device

Never hose the device down with
water. Never use aggressive clean-
ing agents or solvents. This could
damage the appliance.
• After use, empty the stainless steel con-
tainer ( 9):
- Opening the drain plug to allow
the vacuumed liquid to drain out
( 10). A liquid residue remains
in the container.
To remove all residual liquids, fold
down the bow handle (1) and
take off the motor head (
the bow handle with the locking
levers (14), hold the stainless steel
container (9) with one hand on the
bow handle and the other on the
bottom of the container and pour
out the residual liquid.
• Clean the waste tank with a damp
cloth.
• Wash the foam filter (
warm water and soap, and allow to
dry.
GB MT
28).
3): fix
21) with luke-
39