Software Version; System Reset - Renkforce DAB 1 -808171 Bedienungsanleitung

24. Software Version

The software version display cannot be changed and is only included for reference. Ensure that your radio is
on and in DAB mode.
(1) To display the software version, keep the INFO button pushed for two seconds.
(2) Push one of the frequency buttons until the bottom line of the display shows „SW version". Push the SELECT
button to call the SW version function. The version number is then displayed in the bottom line of the display.
Push the INFO button to return to the regular display.

25. System Reset

If your radio has any functional problems of if numbers are missing or incomplete in the display, proceed as
follows:
(1) Hold down the INFO button for two seconds.
(2) Push the TUNING buttons until the display shows „Factory Reset". Then push the SELECT button.
(3) If you want to perform a system reset, push the SELECT button again. The radio then performs a complete
reset. All stored stations and station lists are deleted.
(4) After a system reset, a new station scan is performed in the DAB band. If function problems occur due to
electrostatic discharge, just perform a system reset (you need to disconnect the device from the mains for
this) and continue using it as always.
57