Data Plate; Technical Data; Packaging, Transport And Storage; Delivery - Homa Solestar Originalbetriebsanleitung

3.3.1. Data plate

No. Description
1 Typ description
2 Serial number
3 Impeller diameter
4 Temperature of medium
5 Immersion depth
6 Weight
7 Hmax (delivery head max)
8 Hmin (delivery head min)
9 Qmax (delivery volume max) 22
10 Standard
11 Construction product test lab
12a Year type test
12b Declaration of performance
13 Build year

3.3.2. Technical data

The motor consists of a stator and the motor shaft with
the rotor set. The lead for supplying power is designed for
the maximum mechanical power in accordance with the
characteristic curve or data plate of the pump. The shaft
bearings are robust, maintenance-free and permanently
greased roller bearings.
General data
Mode of operation
Permissible temperature of medium
Speed
IP Code
Cable length
Voltage
Discharge outlet
Intake
Maximum discharge head
Maximum delivery rate
Collecting tank volume
Motor output
20 | EngliSH
No. Description
14 Motor type
15 IE Marking
16 Frequency
17 Voltage
18 Nominal current
19 Motor RPM
20 Power P1
21 Cos phi
Insulation class
23 Power P2
24 Start condenser
25 Operating condenser
26 Protection class
27 Operating class
28 Text field sales
S3 30%
40°C
2900 rev/min
IP55
3 m
230V / 50Hz / 1Ph
¾" with check valve
8mm / 10mm
5m
70 l/min
13l
0.12kW

4. Packaging, Transport and Storage

4.1. Delivery

After receipt, the shipment must be checked for damage
and completeness immediately. In the event of any de-
ficiencies, the transport company and the manufacturer
must be informed on the day of receipt, as no claims can
otherwise be made or considered valid. Any damage must
be noted on the delivery or transport receipt.

4.2. Transport

Do not throw or tip the lifting unit during transport.
Make sure that the lifting unit does not come into con-
tact with sharp edges. Protect the lifting unit from heavy
blows. The products are shipped in suitable packaging
by the manufacturer or supplier. This generally excludes
damage during transport and storage. Should you change
locations frequently, save the packaging carefully for
re-use.

4.3. Storage

Newly delivered products are prepared for up to 1 year of
storage. If the product is being placed in interim storage, it
must be thoroughly cleaned before being stored!
The following must be observed for storage:
• Place product securely on a fixed base and secure
against tipping over.
• In addition, ensure that the equipment is stored in dry
areas.
• Products with vacuum and/or pressure connections
must have these tightly closed to prevent contami-
nation.
• During extended storage the shaft must be protected
against moisture, sunlight, heat and frost.
If you observe these regulations, your product can be
stored for a longer period of time. However, note that the
elastomer parts and coatings are subject to natural em-
brittlement.

4.4. Materials returned

Products that are returned to the factory must be clean
and correctly packaged. „Clean" means that the product
has been cleaned of contaminations and that it has been
contaminated in the event of use with mediums that are
hazardous to health. The packaging must protect the prod-
uct from damage. Please contact the manufacturer before
returning the product.