Setup Codes - Yamaha DSP-A595 Bedienungsanleitung

Presetting the remote control transmitter
Perform the presetting procedure for each component you want to control with this remote control transmitter.
Note: If your component does not respond to any of the codes listed for the manufacturer, use the original remote control that
came with the component.
To control your components
(MD recorder, DVD player,
TV etc.)
1. Turn on the component to be used.
2. Set the SELECTOR DIAL to the
desired component (TAPE/MD,
DVD/LD, TV etc.).
3. Press both VOLUME buttons (
) at the same time until the
indicator flashes twice.
4. Use the numeric buttons to enter the
four-digit manufacturer's code for
the component to be used. Make
sure that the indicator flashes twice.
If the indicator does not flash, repeat
step 3 and re-enter the code.
5. Press POWER (or any other button)
on the remote control transmitter to
check if you have preset the code
correctly. If the component cannot
be controlled using the remote
control transmitter, try entering
another code for the same manufac-
turer.
42

SETUP CODES

To use a second (and third) VCR
You can use the CBL/DBS and/or DVD
MENU positions to control a second
VCR (and/or third) if a CBL (or DBS) or
DVD player is not used.
If you are using the DVD MENU position
for a second (or third) VCR, you must
preset a code for an LD player to the
DVD/LD position.
1. Turn on the VCR to be used.
2. Set the SELECTOR DIAL to the
CBL/DBS or DVD MENU position.
3. Press both VOLUME buttons (
) at the same time until the
indicator flashes twice.
4. Press MUTE.
5. Use the numeric buttons to enter the
four-digit code for a second (or third)
VCR. Make sure that the indicator
flashes twice. If the indicator does
not flash, repeat step 3 and 4, and
re-enter the code.
6. Press POWER (or any other button)
on the remote control transmitter to
check if you have preset the code
correctly. If the VCR cannot be
controlled using the remote control
transmitter, try entering another
code for the same manufacturer.
Returning to the default code
To return all components to the default
code, follow these steps.
1. Press both VOLUME buttons (
) at the same time until the
indicator flashes twice.
2. Enter the code number "9987".
3. Make sure that the indicator flashes
twice.
To return each component to the default
code, follow these steps.
1. Set the SELECTOR DIAL to the
component to be return to the
default code.
2. Press both VOLUME buttons (
) at the same time until the
indicator flashes twice.
3. Enter the code number "9999".
4. Make sure that the indicator flashes
twice.
The following codes are preset as the
default code.
Default codes
POSITION Component Code
TV TV 0037
CBL/DBS DBS tuner 2455
VCR VCR 3072
DVD/LD DVD player 4545 YAMAHA
CD CD player 6187 YAMAHA
TAPE/MD Tape deck 8524 YAMAHA
*1: U.K. and Europe models
*2: China and General models
We recommend that you write all code
numbers you have preset on the "Quick
Reference Card".
*1 Code *2
0047
2566
3060