Operation - Silvercrest SAST 18 A1 Bedienungsanleitung

Operation

ATTENTION!
► The suction opening must always be open and may not be blocked .
Blockages lead to overheating and damage to the motor .
► Use the wet-suction nozzle 5 only at level I (low/wet suction
NOTES
► Make certain that the HEPA filter z is inserted before using the appliance .
► When vacuuming liquid, do not exceed the MAX marking in the dirt
container i .
► If the motorised brush attachment 6 is blocked so that the brush can no
longer turn, the charge indicator lamp w flashes red after approx . 15 seconds
of the blockage, the working light t goes out and the appliance stops
vacuuming . If this happens, remove the blockage as described in the section
"Cleaning the brush attachment" . Slide the On/Off switch q to the "OFF"
position . To restart the appliance, slide the On/Off switch q to position I
or II .
1) Remove the appliance from the wall bracket 7 or, if you are not using the
wall bracket 7, remove the barrel plug 9 from the socket .
2) If required, place the appropriate nozzle in the suction opening . See section
"Using accessories" .
3) To switch the appliance on, slide the On/Off switch q forwards into
position I (= low power/wet suction
The charge indicator lamp w lights up yellow at level I, green at level II .
The working light t lights up .
4) To switch the appliance off, place the On/Off switch q back to the "OFF"
position . All lamps go out .
NOTE
► After you have vacuumed up liquids, clean the dirt container i
immediately . Otherwise, bacteria or mould will build up inside! Ensure that
the HEPA filter z is completely dry before using the appliance again .
SAST 18 A1
) or position II (= high power) .
GB │ MT
) .
│ 51 ■