Maintenance; Safety Instructions; Function Check; Exclusion Of Liability - Steelcase Universal Lockers Bedienungsanleitung

_______________________________________________________________
6

Maintenance

6.1 Safety instructions

CAUTION
Damage to product
Damage to the product is possible
whenever servicing or repair tasks are
carried out incorrectly.
Have only qualified personnel

complete such tasks.
Only use suitable tools for these
acitivities!

6.2 Function check

The components of the Universal Lockers
product should be checked for correct functioning
at regular intervals.
Inte Inspection Function
rval point check
Regu- Fastening Position,
elements of attachment
larly
the Universal and
Lockers condition of
product fastening
elements
-||- Fastening Position and
elements of attachment
accessories
Table 6-1: Function check
6.3 Maintenance
Only authorised and qualified personnel may carry
out maintenance work. Please contact our
Customer Service Department in this regard (see
Repairs and spare parts
134917
Required Action (if
condition necessary
)
The
Tighten
fastening
screws/bol
elements of
ts; replace
the
defective
Universal
fastening
Lockers
elements
product are
correctly
tightened
and not
damaged.
Accessories Remove
assembled accessory,
properly as correct
described in accessory
installation position,
fasten
instructions
accessory
8
).
Risk of injury and damage.
The fastening screws may tear if the
assembled Universal Lockers product is
lifted.
Exercise due caution when transporting

or moving the Universal Lockers
product.
CAUTION
Using unapproved spare parts may
cause damage to the product.
Only components provided by Steelcase

may be used as spare parts. Coordinate
the installation of differing parts with
Steelcase.
Comply with the stated

maintenance and inspection
intervals.

6.3.1 Exclusion of liability

Steelcase assumes no liability or warranty in the
Liability on page 2
following cases (see
■ Inadequate monitoring of the product
components (function checks)
■ Improper maintenance
■ Maintenance by third parties
■ Maintenance by unqualified and unauthorised
personnel
■ Use of components and adaptations that do not
originate from Steelcase
■
Unauthorised changes to the product with
regard to its construction and design
■ Intentional misuse
1.1 I ntended use
■ Improper use (see
Maintenance
):
)
11