Cleaning And Maintenance - MPM MKE-13 Bedienungsanleitung

temperature. After the heating time elapses, the hob will switch off, which will be signaled by
a sound.
CAUTION! If you do not declare the heating time, the appliance will automatically switch off after 120 minutes.
5. The appliance is equipped with a key lock button. Press the button (7) to lock the keypad and
hold it briefly to unlock the keypad. Locking the keypad is signaled by lighting of the control
lamp (6).
6. If you lift the pot/pan or move it away from the cooking zone, the heating process will stop
automatically ("EO" message). The hob will resume the process using the previous settings
if you put the pot/pan back on the heating zone within 60 seconds. Otherwise the hob will
switch off automatically.
7. You can stop the heating process at any moment using the "ON/OFF" button (11).
CAUTION! The heating plates can be hot after use. Do not touch.
8. When the heating process is over, take the pot/pan away from the heating zone but do not
unplug the hob from the mains while the fan cooling the inside of the appliance continue to
work. You can safely unplug the hob only after the cooling fan stop.
9. When the plates cool down, clean the appliance (see: "CLEANING AND MAINTENANCE").
ERROR TABLE: CAUSES AND SOLUTIONS
ERROR
CODE
E0 No pot/pan in the heating zone. Incorrect cookware.
E1 Electrical failure/ short circuit.
E2 Damaged temperature sensor.
E3 Power supply voltage too high.
E4 Power supply voltage too low.
E5 Ceramic hob or cookware temperature too high. Empty
cookware.
E6 Cooling fan(s) damaged.

CLEANING AND MAINTENANCE

Clean the device after each use. Disconnect the device and wait until it gets cooler. Do not
use petrol, thinners, brushes and paste to clean the device. Wipe the device with damp cloth
with some dishwash. Using the vacuum cleaner remove the dirt from the air ducts and the
fan grid. Clean the ceramic surface and the control panel with soft cloth and delicate means
for cleaning ceramic surfaces. Take care and prevent running water on the device (water may
cause the damage of the device). Never immerse the device and the power cord in water or
other liquid.
CAUSE SOLUTION
Put a pot/pan in the heating zone. Make sure your
cookware is compatible with induction hobs.
Contact an authorised service centre.
Contact an authorised service centre.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Make sure the power supply parameters correspond to
the ones presented on the product's nameplate.
Wait until the temperature of the hob/cookware goes
down. Fill the cookware.
Turn off the appliance. Wait until it cools down, clean
the airflow grills and turn on the hob again. Contact an
authorised service centre.
17