Torch Installation Remote Junction Box - ESAB PT-37 Bedienungsanleitung

SECTION 3
3.4

Torch Installation Remote Junction Box

1. Remove cover. Mount box. Connect extension cable between the power supply and remote junction box.
Refer to remote junction box instruction manual. Note that the solenoid is wired to the power supply /
extension cable receptacle side of the box.
2. Connect the air hose to the quick-connect fitting.
3. Connect the torch cable male receptacle to the panel receptacle. Check orientation of the sockets to en-
sure a correct fit.
4. Replace cover.
22
INSTALLATION