Keypad Lighting; Stand Alone Programming Mode; Activate Programming Mode; Clear Address - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

26
6.5

Keypad lighting

- Operating unit at EU BUS-2
Keypad lighting is set via the central control unit in no-load status (no operating procedure) at a low
brightness level so that the keypad can be identified in the dark. It is switched to the full brightness
level for 5 seconds when a key is activated or a transponder is held in the reading range (operating
procedure).
- Operating unit at EU Conventional
In its state at the time of delivery, the keypad lighting for the no-load status (no operation) is
deactivated. If permanent backlighting is desired, the brightness for the no-load status can be set in 16
stages from "off" to "maximum brightness" (via the programming of the EU or in the "stand alone"
programming mode, see 7.5).
Maximum brightness during operation is not affected.
7.

Stand alone programming mode

To program in this mode, only the 12 V DC operating voltage is required.
7.1

Activate programming mode

Press the "armed" "disarmed"
keep pressed. Apply the operating voltage. As soon as the programming
mode is activated, the three LEDs flash every second. Release keys.
7.2

Clear address

Activate key "1" to clear an already allocated address.
7.3

Load standard values

Activate key "2" to create the condition on delivery. (Range, illumination and transponder
detection. An already allocated address is not altered).
7.4

Adjustment mode - range

Activate key "3" to activate the adjustment mode. Adjustment is described in detail in Chapter 6.4.
Activate key "3" again to exit the adjustment mode.
7.5 Keypad lighting
If you require permanent illumination, the brightness for the no-load status can be set in steps
using button "4" and "5" (see 6.5).
Button "4": Every time the button is activated, the illumination becomes gradually darker until it is
fully switched off.
Button "5": The brightness increases in steps until it reaches maximum brightness.
The set value is permanently saved when the programming mode is exited.
7.6

Exit programming mode

Áctivate the "X" key.
Mounting and Connection Instructions IK3 Operating Unit with Keypad
, and "I" keys (Info) simultaneously and
armed disarmed
i
Info