Activate Adress Allocation Mode; Address Indicator; Manual Address Allocation Via Central Control Unit - Honeywell IDENT-KEY 3 Montage, Anschluss, Anleitung

22
6.2.2 Activate address allocation mode
Activate address allocation mode via the MB-
programming (function 509). The operating unit is
switched to this mode via the EU.
The address allocation mode at the operating unit
is indicated by the bottom flashing green LED
(lights up briefly followed by a long pause
Switch off the address allocation mode via the programming.
6.2.3 Address indication
The address allocation mode must be activated
(see above).
The address indicator is for monitoring newly defined
addresses or for a later control.
- Tens digit: Upper LED
Each flash indicates the tens digit of the allocated address.
Example: Flashes 2 x = 20
- Units digit: Middle LED (yellow)
Each flash indicates the ones digit of the allocated address.
Example: Flashes 4 x = 4
The address allocation mode is then displayed in the lower LED.
Repeat display of addresses:
Hold the transponder briefly in the reading range of the operating unit. A brief acoustical
acknowledgement confirms the request to display and restarts the display sequence. The bottom LED
remains dark when the address is displayed.
6.2.4

Manual address allocation via central control unit

Enter the unique number (serial number) of a new operating unit plus the desired address when
programming the central control unit. (WINFEM or LCD operating unit, depending on the central
control unit) and transmit to the EU. The EU transmits the unique number plus the address to the
operating unit. If the received unique number corresponds with the number defined in the operating
unit, the operating unit stores the address.
Address acknowledgement: After approx. 1 sec., the LEDs indicate the newly allocated address
(see 6.2.3).
Programming
Enter unique
number
plus adress
Programming
PC/Laptop with
WINFEM Advanced
COM1...4
Enter unique
number
plus adress
Mounting and Connection Instructions IK3 Operating Unit with Keypad
).
(green)
Unique number
+ address
IDCU
BUS-2
Unique number
+ address
RS-232
F I
F I
This example shows address 24
Unique number
+ address
EU
BUS-2
Unique number
+ address
EU
conv.
Address allocation
mode indicator
Tens digit (green)
Units digit (yellow)
F i
1 2 3
4 5 6
7 8 9
3
r 0