Assembling The Vacuum Cleaner; Safety Precautions - Vitek VT-1825 B Die Betriebsanweisung

ENGLISH
16. Do not use the vacuum cleaner with-
out the dust container and filter unit at-
tached.
17. When unwinding the power cord, hold
the cable in your hands and don't let the
plug hit the floor.
STORE THE INSTRUCTIONS IN A CON-
VENIENT PLACE
Description
1. Turbo brush
2. Telescoping tube
3. Flexible hose
4. Dust container
5. On/off button
6. Large ring
7. Main housing
8. Power control
9. Power cord winder
10. Outgoing air filter cover
11. Outgoing filter
17. Universal attachment
18. Attachment for hard-to-reach places
Description of the dust container
12. Top lid with handle for removing the
container
13. HEPA-filter self-cleaning handle
14. Filter unit (preliminary mesh screen and
main HEPA-filter)
15. Lower part of the container with lid for
removing trash
16. Lower container lid latch

SAFETY PRECAUTIONS

If suction power decreases abruptly
while cleaning, immediately turn off
of vacuum cleaner and check the tel-
escoping tube or flexible hose for
foreign objects. Turn off the vacuum
cleaner, then unplug it from the power
outlet. Clear the obstruction and only
then proceed with cleaning.
• Do not use the vacuum cleaner in the
immediate vicinity of very hot surfaces,
1825.indd 6 1825.indd 6
next to ash trays, or where flammable liq-
uids are stored.
• Insert the plug into the outlet only with
dry hands.
• Before beginning to clean, remove sharp
objects from the floor to avoid damage to
the filter unit.
• When pulling the plug from the outlet, al-
ways grasp the plug, not the power cord.

ASSEMBLING THE VACUUM CLEANER

Completely unpack the vacuum cleaner
and check it for damage. Factory defects
or damage occurring in shipment are cov-
ered by the VITEK warranty.
Before turning on the vacuum cleaner,
make sure that the voltage of the electri-
cal system matches that of the vacuum
cleaner.
Always turn off the vacuum cleaner and
unplug it from the outlet before chang-
ing the brushes/attachments, and be-
fore performing maintenance on it.
1. Attaching and removing the flexible
hose (drawing 4)
Insert the flexible hose (3) into the air
opening located on the front of the vacu-
um cleaner housing. Insert the hose until it
snaps, confirming a proper connection.
To remove the flexible hose, press the fixa-
tion button and disconnect the hose.
2. Attaching the extension tubes and
brushes
- Attach the telescoping extension tube to
the flexible hose (drawing 1). Extend the
lower part of the telescoping tube to the
desired length by pressing the fixation
button (drawing 2).
- Select the desired attachment: the turbo
brush (1), universal attachment (17) or
the attachment for hard-to-reach places
(18). Attach it to the telescoping exten-
sion tube (drawing 3).
6
05.10.2009 12:41:35 05.10.2009 12:41:35