Providing A Breath Sample; Test Passed; Test Failed - Dräger Interlock 5000 Gebrauchsanweisung

3.3.2

Providing a breath sample

1. Remove the handset from
the holster.
2. If necessary, insert a new
mouthpiece into
respective opening. When
doing so, ensure that the
mouthpiece tab is correctly
aligned with the slot in the
handset (1).
3. Blow evenly into the mouth-
piece as long as a continuous
tone sounds. The blue LED
goes out when blowing begins
(only for Interlock 7000).
or
With installed camera - optional:
Hold handset with the display in the direction of the camera.

Depending on the configuration, the blue LED within the camera

may flash when the handset is recognized.
Depending on the configuration, a breath sample may only be

possible if the blue LED is flashing and the handset is recognized.
Blow evenly into the mouthpiece as long as a continuous

tone sounds.
With anti-circumvention activated (blow/suck) – optional:
Blow evenly into the mouthpiece as long as a continuous signal

tone sounds, followed immediately (the signal tone ceases)
without pause by sucking hard until a short signal tone sounds.
If the breath sample is not provided in the correct way with the blow

and suck breathing technique, Repeat test is displayed.
Dräger Interlock 5000 / 7000
the
Confirm with the OK button.

The instrument will request a repeated breath sample.
If the breath sample flow is too hard or too soft, a corresponding

message is displayed.
Confirm with the OK button.

The instrument requests a repeated breath sample.

1
After an adequate breath sample, the test result is displayed with

Test passed or Test failed.
3.3.3

Test passed

The measured breath alcohol concentration is below the set limit value.
Test passed is displayed and the LED glows green (only for

Interlock 7000).
00233351.eps
The vehicle is cleared to start, Free Start Time is displayed and a

timer specifies how long the vehicle can be started.
After starting, the instrument is in stand-by mode and Drive Safely!

is displayed.
Attach handset to the holster again.

3.3.4

Test failed

The measured breath alcohol concentration is above the set limit value.
Test failed is displayed and the LED glows red (only for

Interlock 7000) followed by Next test in: with a timer displaying
the remaining disabled hours, minutes and seconds. The LED
remains lit until the instrument is ready to accept a further sample.
After an intermediate phase displayed via Preparing for test,

Ready for test. Please blow is displayed.
Provide further breath samples if necessary.

Use
9