Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Connection - BORETTI BIKP-91 Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für BIKP-91:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Electrical connection

• The installation of this appliance and the connection to the electrical network should be entrus-
ted only to an electrician perfectly to the fact of the normative regulations and which respects
them scrupulously.
• Protection against the parts under tension must be ensured after the building-in.
• The data of connection necessary are on the stickers place on the hob casing near the con-
nection box.
• The connection to the main must be made using an earthed plug or via an omnipolar circuit
breaking device with a contact opening of at least 3 mm.
• The electrical circuit must be separated from the network by adapted devices, for example:
circuit breakers, fuses or contactors.
• If the appliance is not fitted with an accessible plug, disconnecting means must be incorporated
in the fixed installation, in accordance with the installation regulations.
• The inlet hose must be positioned so that it does not touch any of the hot parts of the hob or
oven.
Caution!
This appliance has only to be connected to a network 230 V~ 50/60 Hz.
Connect always the earth wire. Respect the connection diagram.
The connection box is located underneath at the back of the hob casing. To open the cover use a
medium screwdriver. Place it in the slits and open the cover.
Mains
230V~ 50/60 Hz (BE)
400V~ 50/60Hz (BE)
400V~ 50/60Hz (NL)
* calculated with the simultaneous factor following the standard EN 60 335-2-6
Connection of the hob
For the various kinds of connection, use the brass bridges which are in the box next the terminal.
Monophase 230V~1P+N
Put the 1st bridge between terminal 1 and 2 and between 2 and 3, the 2nd between 4 and 5.
Attach the earth to the terminate "earth", the neutral N to terminal 4 or 5, the Phase L to one of
the terminals 1, 2 or 3.
36
Connection
Cable diameter
1 Phase + N
3 x 4 mm²
2 Phases + N
4 x 2.5 mm²
3 Phases + N
5 x 2.5 mm²
Cable
Protection
calibre
H 05 VV – F
40 A
H 05 RR – F
H 05 VV – F
25 A
H 05 RR – F
H 05 VV – F
3 x 16 A*
H 05 RR – F

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis