Installation; Connection; Setup; Wall Mounting - Doro Comfort 3005 Bedienungsanleitung

This device is intended for the analogue telephone network lines in AT, BE, BG, CH, CY, CZ, DE,
DK, EE, ES, FI, FR, GB, GR, HU, IE, IS, IT, LV, LT, LU, MT, NL, NO, PL, PT, RO, SI, SK, SE.

Connection

Connect the curly cord to the handset and to the socket marked q on the unit.
1.
2. Connect the mains adapter to an electrical wall socket and then to the socket marked DC 9V
on the unit.
Connect the telephone line cord to a network wall socket and then to the socket marked K
3.
on the unit.
4. Lift the handset and listen for the dial tone.
Note! Use supplied telephone line cord, an existing cord from a previous phone may not be
compatible.

Setup

Press w.
1.
CONTRAST is displayed. Press 0 to change, press V to continue without changes.
2.
Select desired contrast setting (2=normal) using v/V. Press 0.
3.
TIME/DATE is displayed. Press 0 to change, press V to continue.
4.
To set hour (00-23) use v/V. Press 0.
5.
Select desired minute using v/V. Press 0.
6.
Select desired month using v/V. Press 0.
7.
Select desired date using v/V. Press 0.
8.
Select desired weekday using v/V. Press 0.
9.
10. ENGLISH is displayed. Press 0 to change, press V to continue.
11. Select desired language using v/V. Press 0.
12. VOICE is displayed. Press 0 to change, press V to continue.
13. Select ON or OFF using v/V. Press 0.
14. RECALL is displayed. Press 0 to change, press V to continue.
15. Select the desired setting using v/V. 100 for AU/UK/EU, 270 for FR and 600 for NZ.
Press 0.
16. ANSWER DELAY is displayed. Press to change, press V to continue.
17. Select 2, 4 or TS using v/V. Press 0.
18. ANSWER MODE is displayed. Press 0 to change, press V to continue.
19. Select ANSWER/RECORD or ANSWER ONLY using v/V. Press 0.
20. PIN CODE is displayed. Press 0 to change, press V to continue.
21. Use the numeric keypad to enter the code (default=0000). Press 0. Enter the new code (4
digits). Press 0. If the code is not accepted/correct you will hear a short beep, repeat step
19 and 20.
22. PRIVACY MODE is displayed. Press 0 to change, press V to continue.
23. Select ON or OFF using v/V. Press 0.
To change settings for time, language or contrast etc. later on, repeat steps as above.

Wall mounting

The phone can be wall mounted.
English

Installation

1