en
Proceed as follows:
S Before cleaning: Switch off the
appliance.
S Pull out the mains plug or switch off
the fuse!
S Clean the appliance with a soft cloth,
lukewarm water and a little pH neutral
washing up liquid. The rinsing water
must not run into the light.
S Wipe the door seal with clear water only
and then wipe dry thoroughly.
S Rinsing water must not run through the
drainage hole into the evaporation area.
S After cleaning reconnect and switch on
the appliance.
Note
Regularly clean condensation channel
and drainage hole, Fig. 8, with cotton
buds, etc. so that the condensation can
run out. The upper condensation channel
can be taken out for cleaning.
Tips for saving energy
S Install the appliance in a dry, well
ventilated room, but not in direct
sunlight and not near a heat source
(e.g. radiator, cooker, etc.). If required,
use an insulating plate.
S Allow warm food and drinks to cool
down before placing in the appliance!
S When thawing frozen products,
place them in the refrigerator. The low
temperature of the frozen products
cools the food in the refrigerator.
30
S Open the appliance doors as briefly
as possible.
S Occasionally clean the rear of the
appliance with a vacuum cleaner or
paint brush to prevent increased power
consumption.
Operating noises
Quite normal noises
Humming
refrigerating unit is running.
Bubbling, gurgling or whirring noises
refrigerant is flowing through the tubing.
Clicking
motor is switching on or off.
Preventing noises
The appliance is not level
Please align the appliance with
a spirit level. Use the height adjustable
feet or place packing underneath them.
The appliance is not free standing
Please move the appliance away from
adjacent furniture or appliances.
Drawers, baskets or storage areas
wobble or stick
Please check the removable parts and
re insert them if required.
Receptacles are touching each other
Move the bottles or receptacles slightly
away from each other.