Continuous Operation; Technical Data; Angle Grinder - Hilti AG 180-20 (D/P) Original Bedienungsanleitung

3.5

Continuous operation

Option: AG 180-20 P
Pressing the safety trigger with the on/off switch pressed switches the angle grinder to continuous operation.
• To switch the angle grinder off, press and then release the on/off switch.
3.6 Guard with cover plate
When using abrasive cutting discs to cut or slit metals, the guard with cover plate must be fitted to the
tool. When using diamond cutting discs it is recommended that the guard with cover plate is fitted.
4 Consumables
Use only synthetic-resin-bonded, fiber-reinforced discs with a maximum Ø of 180 mm approved for a
rotational speed of at least 8500 rpm and a peripheral speed of 80 m/s.
The maximum permissible grinding disc thickness is 8 mm and the maximum permissible cutting disc
thickness is 3 mm.
ATTENTION! When cutting or slitting with cutting discs, always use the guard with cover plate.
Discs
Abrasive cutting disc
Diamond cutting disc
Abrasive grinding disc
Diamond grinding disc
Suitability of discs for the equipment used
Equipment
Guard
Guard with cover plate
Side handle
Clamping nut
Clamping flange
5

Technical data

5.1

Angle grinder

For rated voltage, rated current, frequency and/or input power, refer to the country-specific rating plate.
If the product is powered by a generator or transformer, the generator or transformer's power output must
be at least twice the rated input power shown on the rating plate of the product. The operating voltage of
the transformer or generator must always be within +5 % and -15 % of the rated voltage of the product.
Rated power input
Rated speed
Maximum disc diameter
Weight in accordance with EPTA procedure 01
Drive spindle thread
Thread length
Ambient temperature for operation
Storage temperature
20 English
2
Application
Cutting, slitting
Cutting, slitting
Rough grinding
Rough grinding
AC­D AG-D
— X
X —
X X
X X
X X
Designation
AC­D
DC­D
AG­D, AF­D, AN­D
DG­CW
AF-D AN-D DG­CW
X X
— —
X X
X X
X X
AG 180-20 D/ AG 180-
20 P
2,000 W
8,500 /min
180 mm
5.2 kg
M14
15 mm
−17 ℃ ... 60 ℃
−20 ℃ ... 70 ℃
2075442
*2075442*
Material
Metal
Mineral
Metal
Mineral
DC­D
X —
— X
X X
X X
X X