OK. ODW 60032 FS A2 Gebrauchsanweisung Seite 19

Adjusting salt consumption
1. Activate the setup mode: Close the door within 60 seconds after power ON, press Start/Pause
6
button and hold for 5 seconds, the machine will enter setting mode which is indicated by the
alternatingly blinking indicator lights of
2. Adjust level of salt consumption: Press the Start/Reset button to select the proper setting
according to your local environment. Follow table below to find correct setting.
Water Hardness level
°dH
1)
0-5
6-11
12-17
18-22
23-34
35-55
3. The product will exit the setup mode automatically 5 seconds after last setting/operation of
switch.
Note:
German degree of measurement for the water hardness
1)
Millimol, international unit for water hardness
2)
* Factory setting
)
Contact your local water board for information on the hardness of your water supply.
IM_ODW60032_160118_V04_HR.indb 19
Setting
mmol/l
2)
0-0.94 1
1.0-2.0 2
2.1-3.0 3
3.1-4.0 4 *
4.1-6.0 5
6.1 - 9.8 6
19
and .
Digital display stalls
EN
18/1/16 2:00 PM