Pioneer PDP-503HDE Bedienungsanleitung Seite 65

HOW TO SET THE FACTORY PRESETTINGS
Press and hold down CLEAR on the Media Receiver while it is in standby mode. Then press STANDBY/ON
on the Plasma Display or 0 – 9 on the remote control unit to turn the Plasma Display System on.
All setting items (except TV channel) return to the factory presetting.
A
• Running the factory presetting operation also clears the password.
You can run the Auto Installation again by using the following steps.
1
Turn on the power of the Plasma Display and the Media Receiver.
2
Press MENU. (Make sure the menu screen displays.)
3
Press to select "Setup".
4
Press ENTER.
A
• If the password setting screen displays, you need to enter your password.
• If you forget your password, refer to HOW TO SET THE FACTORY PRESETTINGS above.
5
Press / to select "Auto Installation".
6
Press ENTER.
"Auto Installation completed" displays. After that, the screen changes to the TV mode.
The secret number is
A
• As a precautionary measure, make a note of your secret number above, scissor it from this manual, and keep it in a
familiar place.
1
* SRS and the
SRS technology is incorporated under license from SRS Labs, Inc.
* 1 FOCUS and the
FOCUS technology is incorporated under license from SRS Labs, Inc.
A
• Products above are a trademark or registered trademark of corporation.
About the plasma panel's protection function
The brightness of this display will deteriorate slightly when an image with little movement such as a photograph or computer
image is continuously displayed. This is caused by the plasma panel's protection function which detects images with slight
movement and automatically adjusts brightness to protect the display, and is not a malfunction.The screen-saver function
begins operating when the display detects no or little screen movement for a period of about three minutes.
L
Panel sticking and after-image lag
• Displaying the same images such as still images for a long time may cause after-image lagging. This may occur in the
following two cases.
1. After-image lagging due to remaining electrical load
When image patterns with very high peak luminance are displayed for more than 1 minute, after-image lagging may occur
due to the remaining electric load. The after-images remaining on the screen will disappear when moving images are
displayed. The time for the after-images to disappear depends on the luminance of the still images and the time they had
been displayed.
2. After-image (lag image) due to burning
Avoid displaying the same image on the Plasma Display continuously over a long period of time. If the same image is
displayed continuously for several hours, or for shorter periods of time over several days, a permanent after-image
may remain on the screen due to burning of the fluorescent materials. Such images may become less noticeable if
moving images are later displayed, but they will not disappear completely.
• The energy save function can be set to help prevent damage from screen burning (See page 36-37).
63
PDP-503HDE/(E)-g
symbol are trademarks of SRS Labs, Inc.
symbol are trademarks of SRS Labs, Inc.
63
.
8/31/02, 5:15 PM