18_9.Cleaning Aluminium Parts; 18_10.Parts Inspection; Dismantling The Unit - Specialised Technician - Arneg Kiruna Handbuch

Kiruna
English

18_9.Cleaning aluminium parts

DO NOT use acid or alkaline detergents (e.g. bleach) which could corrode the

surface
DO NOT use rough or abrasive materials or metallic scrapers that could

scratch the aluminium surfaces
DO NOT use steam cleaning equipment

DO NOT use dirty cloths

Use a soft cloth with a neutral detergent or soap and lukewarm water (max

30°C).
Immediately remove all traces of water or detergent using a dry cloth in order

to avoid the formation of marks.
All cleaning operations, including disinfection, rinsing and drying must be
performed carefully, removing all traces of water or detergent so as to avoid the
proliferation of bacteria that is harmful to health. Parts left to dry with residual
detergent of disinfectant may be damaged.
Remove any elements such as sponges, clothes, detergent residue, or water
from the floor that could cause slipping and accidental falls.

18_10.Parts inspection

Once cleaning, disinfection, rinsing, and drying operations have been completed,
carefully check that all the parts are perfectly clean and dry and have not been
damaged or excessively worn. If necessary, replace them.
Attach the elements once perfectly dry and restore the electrical power supply. Once
internal operating temperature has been reached, the unit can be loaded with the
products to be displayed.

19.Dismantling the unit - specialised technician -

The unit must be disposed of in accordance with your country's waste management
legislation and in respect of our environment. This product is considered by current
legislation as hazardous waste. It must therefore be collected separately and cannot
be treated as household waste nor sent to a landfill. Before disposing of the unit, the
coolant must be collected and the lubricant oil removed. This product consists of 75%
recyclable materials.
Materials used in construction:
- Stainless steel 18/10 (AISI 304):various trimmings
- Iron profiles and tubes:
- Copper, aluminum:
- Galvanized sheet metal
- Plasticised galvanized sheet metalexternal and internal sheets
- Tempered glass:
- Polyurethane foam (R134a): thermal insulation
- ABS
- PVC:
34
lower frame
refrigeration circuit, electricalsystem, various
trimmings
motor base, lower panels, painted panels
edging glass
side shoulders
bumper profiles, defrost water discharge tube
00 30/01/2012