3
ETIQUETAS
3.1
ETIQUETAS _______________________________________________________________
WARNING
!
Never mow in transport.
If lever is in transport
mode, forward motion will
suddenly increase when mowers
are raised or sut off
Do not use this machine on
slopes greater than 12.5 .
Part of 2810350
!
1. Read operators manual. Do not allow untrained operators to
use this machine.
2. Keep all shields in place and hardware securely tightened.
3. Before you clean, adjust or repair this equipment,
disengage all drives, engage parking brake and stop engine.
4. Keep hands, feet and clothing away from moving parts.
5. Never carry passengers.
6. Keep bystanders away
ADVERTENCIA
!
1. Leer el manual del operador. No permitir
que personas no capacitadas para ello usen
la máquina.
2. Mantener los escudos en su lugar y la
tornilleria debidamente fijada.
3. Antes de limpiar, adjustar o reparar este
equipo, desengranar todos los mandos, aplicar
el freno de estacionamiento y apagar el motor.
4. Mantener las manos, los pies y la ropa
alejados de las piezas en movimiento.
5. No viajar como pasajero ni llevar pasajeros en
máquinas sin asiento para ello.
6. Mantenar a las demás personas alejadas.
7. Si no sabe leer inglés, solicitarle a otra persona
que le lea y explique el contenido de las
etiquetas y del manual de la máquina.
CAUTION
!
Fill fuel tank to 1 inch (25mm) below filler neck.
Do not overfill
WARNING
!
DO NOT USE FOR TOWING
!
Inspect hoses and fabric covers
daily. If worn or damaged,
replace with original quality
WARNING
Part of 2810349
Reels turn when reel levers are in backlap position. Read operator's manual before backlapping.
Temperatures may exceed 150 F (66 C)
Radiator is under pressure. Remove
cap slowly to avoid personal injury
340830
361169
361175
CAUTION
parts.
2811880
!
WARNING
!
To prevent burns, do not touch
muffler or muffler shield.
339237
WARNING
!
365956
DANGER
!
To prevent injury:
Always connect red battery cable
to the positive (+) post FIRST
and the black cable to negative (–)
post LAST.
When removing the battery always
remove negative (–) cable FIRST
and positive (+) cable LAST.
Avoid contact with battery acid.
Keep sparks and flames away from
the battery.
Do not short circuit battery posts.
Do not touch frame or negative
terminal when working on positive
terminal.
ETIQUETAS
DANGER
!
Keep hands and clothing far away from moving
components to prevent personal injury.
Never run an engine without proper ventilation.
Read manual for further information.
BACKLAPPING PROCEDURE
1. Engage parking brake.
2. Turn backlap lockout key to backlap position.
3. Turn all 3 backlapping knobs counter clockwise to
open bypass valves.
4. Start Engine and set throttle to minimum idle speed.
5. Engage reels for backlapping. Reels may turn slowly
with bypass valves open.
6. Slowly close bypass valve for reel to be backlapped
until reel rotates at desired speed.
7. With extreme caution apply lapping compound with a
lond handled brush.
WARNING
CAUTION
!
Torsion spring under extreme tension.
Clamp may turn suddenly. To avoid
injury, unwind spring by tapping on
clamp while loosening nut
DANGER
!
To prevent injury, disengage
all drives, engage parking
brake and stop engine before
working in machine or
emptying grass catchers.
CAUTION
!
To Install the battery
1. Install the battery with terminals toward
frame center.
2. Secure battery to support.
3. Connect positive (+) (red) FIRST.
4. Connect negative (–) (black) LAST.
To use jumper cables:
1. Stop the engine on vehicle with good
battery.
2. Connect RED cable to positive (+) terminal
on good battery and positive (+) terminal
on discharged battery.
3. Connect the BLACK cable from negative (–)
terminal on good battery to frame of
vechile with discharged battery.
4. Start the engine.
3
3002207
337302
340586
361877
336640
E-5