Advice For Saving Energy; Technical Data - Beper 50.132 Betriebsanleitung

EN
Steam iron Use instructions
It is possible to use tap water as well as demineralised water if tap water is to hard.
After ironing, unplug the appliance from the socket and empty the tank.
To empty the tank turn over the iron above the sink (or other).
Otherwise place the iron in vertical position and plug it to the socket.
Select the temperature indicator (8) on "MAX" and steam indicator (3) on steam
symbol
and let the steam come out from the iron by pressing steam switch (4).
CLEANING
Unplug the appliance from the socket.
To remove dirt on the soleplate, use a wet cloth or with a little quantity of non abrasive
detergent when the soleplate is still hot.
For hard dirt, use special detergent.
Always dry the soleplate after cleaning.
Clean the whole iron with a wet cloth without detergent.
Do not use metallic sponge or abrasive detergent.
STORAGE
Always empty the tank (2) after every use.
Unplug the appliance from the socket and let it cool.

ADVICE FOR SAVING ENERGY

The most important part of energy is consumed when used steam. In order to reduce it,
read as follows :
• always start ironing with fabric which need the lower temperature.
• set steam function and temperature as described in the instruction manual.
Iron only when it is necessary. If possible use spray function instead of steam function.
• iron clothes when they are still wet and reduce the steam function. If you use a dryer
machine, select « ironing » program that allow you to easily iron clothes.
• if clothes are enough wet, set the steam indicator on "zero".
• when having a break, store the iron in vertical position.

TECHNICAL DATA

Power: 1800W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the
product without any notice.
19