Remote Controller; Accessories; Inserting The Batteries - REVELL BUGGY 4X4-GBL Bedienungsanleitung

BUGGY
An n tenna
Pivotball front wheel
suspe e nsion
Shock absorbers
Chrome whee e l rims

REMOTE CONTROLLER

Antenna
Power / charge control LED
Reverse switch for
the speed control
Control for setting
the steering angle right/left
Control for setting
the maximum speed
Reverse switch
for steering
1. Remove the cover in the
direction indicated by the arrow.
Caution: Before recharging and after every use, always wait 10 to 15 minutes for the battery to cool down This is in order to avoid damage to the buggy's battery. Never leave the buggy unattended while charging.
1. Switch off the buggy and remote control. (Fig. 1)
2. Disconnect the battery cable from the buggy. Do not force. (Fig. 2)
3. Remove the battery from the buggy as shown, fi rst removing the retaining clips. (Fig. 3)
4. Insert the mains adapter into a plug socket. Connect the NiMH battery to the charger.
The red LED lights up. Do not force. (Fig. 4)
5. The charging process is complete as soon as the light on charger goes out.
6. Remove the charger from the plug socket and disconnect the battery from the charger.
7. Reinsert the battery in the buggy and fasten it with the retaining clips. (Fig. 5)
8. Before use, carefully reconnect the cables on the buggy. (Fig. 6)
After a charging period of approx. 6 - 10 hours, the buggy will drive for about 6 to 10 minutes.
We recommend using a suitable fast charger, available as a Revell accessory in all good
specialist stores.
RC_Anleitung_Buggy_GHz_24503.indd 7 RC_Anleitung_Buggy_GHz_24503.indd 7
Buggy and remote control

Inserting the batteries

2. Insert eight 1.5 V AA batteries according to the
polarity in the battery compartment.
Charging the buggy
Aluminium m oil pressure
shock abs sorbers
Compart tment for NiMH battery
ACCESSORI
Vehicle battery NiM attery NiM
7 2 V 7.2 V / 1500 m
Steering
Trim control
for steering
Trim control
for speed
Speed control
Battery compartment
3. Close the battery
compartment cover
Fig. 1
Fig. 4
ON/OFF switch
under the bonnet
ES
M M H
Ah
230 V AC ada a pter V AC ada
ON/OFF switch
4. Green and red power LEDs on the remote
control indicate: fully charged.
Fig. 2 Fig. 3
Fig. 5
Fig. 6
7
31.03.10 12:12 31.03.10 12:12