Remote Control - REVELL Motion Pilot Bedienungsanleitung

1 helICOPTer
1A Tail rotor
1B ON/OFF switch
1C Anticlockwise rotating rotor
level
1D Clockwise rotating rotor
level
1E Stabiliser
1F Charge socket
3 InserTIng BaTTerIes (reMOTe COnTrOl)
3A Unscrew and
remove the
cover
Attention: The battery and motor must cool down for 10 to 15 minutes before
charging and after every flight. Otherwise they can be damaged. The charging process
must be constantly monitored. Always ensure that the charging process takes place on
a fireproof surface in a fire-resistant environment.
1. Switch off the helicopter.
2. Plug the USB charger into the socket on the remote control or into a USB hub or
USB port on a computer (4A). Now switch on the remote control (only the remote
control, not the helicopter). If the charger is ready for operation, the LED on the top
illuminates red.
3. Now plug the connector on the charger into the side of the model (4B).
The charging process begins automatically.
4. The Power LED on the charger goes out during the charging process and illumina-
tes red when the battery is full (4C). Once the charging is complete, disconnect the
battery from the charter and remove the charger from the USB interface and switch
off the remote control.
The helicopter can fly for approx. 6-8 minutes after a charge time of
approx. 60 minutes.
Warning notice: The LiPo battery does not normally heat up while charging. If it
should become warm or even hot and/or changes to the surface begin to appear,
immediately discontinue the charging process!
The thrust controller (the left controller on the remote control) must point down before
being switched on (5A). Then set the remote control's ON/OFF switch to "ON" (5B).
The power LED begins to blink.
Now set the helicopter's ON/OFF switch to the "ON" (5C). Place the helicopter on the
ground so that the tail points toward you (5D).
Activate the remote control by first moving the thrust controller to maximum and then
back to its starting position. This process lasts for approx. 3 seconds. The helicopter is
ready to start when the headlamp is permanently illuminated red.
14
2A Joystick for thrust
(up /down)
2B ON/OFF switch
2C Power LED
2D Antenna
2E Joystick for forward and
backwards flight as
well as rotation around
the vertical axis
3B Insert 6 x 1.5 V AA batteries
and pay attention to the polarity,
as shown in the battery
compartment.
4 ChargIng The helICOPTer
5 sTarT PreParaTIOn

2 reMOTe COnTrOl

2F Battery compartment
cover
2G Securing screw
2H Turbo button
2I Right trim
2J Left trim
2K Front headlamp on/off
3C Close the battery
cover and secure
with the screw.