Mains Power Supply; Operation - ESAB ESABMig C420 Betriebsanweisung

GB
5.4

Mains power supply

Check that the unit is connected to the correct mains power supply voltage, and that
it is protected by the correct fuse size. A protective earth connection must be made,
in accordance with regulations.
ESABMig C420w/C420sw
Voltage V
Current A
at100% duty cycle
at 60% duty cycle
at 50% duty cycle
2
Cable area mm
Fuse, slow A
NB: The mains cable areas and fuse sizes as shown above are in accordance with Swedish
regulations. They may not be applicable in other countries: make sure that the cable area and fuse
sizes comply with the relevant national regulations.
6

OPERATION

General safety regulations for the handling of the equipment can be found on
page 64. Read through before you start using the equipment!
WARNING!
Rotating parts can cause injury, take great care.
WARNING – TIPPING RISK!
There is a risk of tipping while transportation and operation, if the welding machine leans
o
more than 10 . In that case appropriate securing has to be provided !
C420e
Rating plate with supply connection data
3∼ 50 Hz 3∼ 50/60 Hz
230 400/415
33 19
47 27
52 30
4 x 10 4 x 4
35 25
– 70 –
3∼ 50 Hz 3∼ 60 Hz
500 230
3∼ 60 Hz
440/460