Directive; Declaration Of Conformity; Safety - ESAB ESABMig C420 Betriebsanweisung

GB
1

DIRECTIVE

ESAB Welding Equipment AB, S–695 81 Laxå, Sweden, gives its unreserved guarantee that welding
power source ESABMig C420 from serial number 237 complies with standard IEC/EN 60974–1, in
accordance with the requirements of directive (73/23/EEC) and addendum (93/68/EEC) and with
standard EN 50199 in accordance with the requirements of directive (89/336/EEC) and addendum
(93/68/EEC).
–––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––––
Laxå 2003–03–10
Henry Selenius
Vice President
ESAB Welding Equipment AB
695 81 LAXÅ
SWEDEN
2

SAFETY

Users of ESAB welding equipment have the ultimate responsibility for ensuring that anyone who
works on or near the equipment observes all the relevant safety precautions. Safety precautions
must meet the requirements that apply to this type of welding equipment. The following recommen-
dations should be observed in addition to the standard regulations that apply to the workplace.
All work must be carried out by trained personnel well–acquainted with the operation of the welding
equipment. Incorrect operation of the equipment may lead to hazardous situations which can result
in injury to the operator and damage to the equipment.
1. Anyone who uses the welding equipment must be familiar with:
S its operation
S location of emergency stops
S its function
S relevant safety precautions
S welding
2. The operator must ensure that:
S no unauthorised person is stationed within the working area of the equipment when it is
started up.
S no–one is unprotected when the arc is struck
3. The workplace must:
S be suitable for the purpose
S be free from draughts
4. Personal safety equipment
S Always wear recommended personal safety equipment, such as safety glasses, flame–proof
clothing, safety gloves.
S Do not wear loose–fitting items, such as scarves, bracelets, rings, etc., which could become
trapped or cause burns.
5. General precautions
S Make sure the return cable is connected securely.
S Work on high voltage equipment may only be carried out by a qualified electrician.
S Appropriate fire extinquishing equipment must be clearly marked and close at hand.
S Lubrication and maintenance must not be carried out on the equipment during operation.
C420e

DECLARATION OF CONFORMITY

Tel: + 46 584 81000
– 64 –
Fax: + 46 584 411924