Wps - Connect To The Ap - Silvercrest SWV 300 B2 Bedienungsanleitung Und Serviceinformationen

SilverCrest SWV 300 B2

WPS - Connect to the AP

This is the easiest way to establish a connection to the AP. First, check whether
your end device supports WPS. For further details, please read the operating
instructions for your end device.
1. Press the WPS button (6) on the dual-band wifi range extender for 3
seconds. The Power/WPS LED (3) now flashes for approx. 2 minutes.
2. Within these 2 minutes, please press the connection button (WPS) on your
end device. For further details, please read the operating instructions for your
end device.
Your end device then automatically connects to your dual-band wifi range
extender (AP) and applies all of the settings. Once the connection has been
successfully established, the 2.4G signal LED (1) or the 5G signal LED (2) lights
up. You can then access the dual-band wifi range extender (AP) wirelessly.
If your end device does not support WPS, you can also manually establish the
connection to the dual-band wifi range extender (AP).
172 - English