Interfacekabel; Control Panel - ESAB ESP-600C Bedienungsanleitung

HOOFDSTUK 3

3.7 Interfacekabel

SECTION 4
4.1 Introduction
WARNING
!
CNC-interface (19-pins)

4.2 Control Panel

ESP-600C Plasma Power Source ESP-600C Plasma Power Source ESP-600C Plasma Power Source ESP-600C Plasma Power Source
80
INSTALLATIE
The ESP-600C does not have an ON/O
The main power is controlled through th
disconnect switch.
Do not operate the ESP-600C
Covers Removed.
High voltage components are exp
increasing shock hazard.
Internal component may be dama
because cooling fans will lose ef
Main Power Main Power
Main Power Main Power
Indicator illuminates when input power i
the power source.
Over Temp Over Temp
Over Temp Over Temp
Indicator illuminates when power source
overheated.
Contactor On Contactor On
Contactor On Contactor On
Indicator illuminates when the main con
energized.
Op