ESAB ESP-600C Bedienungsanleitung Seite 117

sectIon 4
4.2 control panel (con't.)
J
K
G - Panel Remote Switch
SECTION 4 Controls the location of current control.
4.1 Introduction
H and L - Remote Connections
H - 19 pin plug for connecting the power source to CNC (remote control)
!
I - Pilot Arc HIGH / LOW Switch
Used to select amount of pilot arc current desired. As a general rule, for 100
amperes and below, a setting of LOW is used. This can vary depending on
gas, material and torch used. High/Low settings are specified in cutting data
included in the torch manual.
I
4.2 Control Panel
• Place in the PANEL position for control using the current po-
tentiometer.
• Place in REMOTE position for control from an external signal
(CNC).
WARNING
h f
117
operatIon
The ESP-600C does
The main power is co
disconnect switch.
Do not operate
Covers Remove
High voltage com
increasing shock
Internal compone
because cooling f
g
a
c
B
D
e
Main Power Main Power
Main Power Main Power
Indicator illuminates w
the power source.