Ingersoll-Rand M-SERIES Installation Und Betriebsanleitung Seite 13

Chain Lubrication
Lubrication of chain should be performed when it is noted that chain is dry.
Use part number 10885 to lubricate.
Load Chain
Measure the chain for stretching by measuring across five link sections all
along the chain, paying particular attention to the most frequently reeved
links. When any five links in the working length reaches or exceeds the
discard length, replace the entire chain. Refer to Dwg. MHP0102
and table. Always use genuine Ingersoll-Rand Material
Handling replacement load chain.
Installing Wire Rope
• Use of other than Ingersoll-Rand wire rope should
be avoided. Internal damage to the unit may result.
1. Install new wire rope assembly, by first rotating
the reel down (direction of arrow in Dwg.
MHP1366) until the anchor hole in the reel is
visible.
NOTICE
• The wire rope must be wrapped by hand twice around the reel for proper operation.
2. The end of the wire rope is inserted down through the anchor hole in the reel and into the groove.
Continue pushing wire rope into groove until the end appears at the top of the reel. Grasp this end and
pull until swaged fitting on the end of the wire rope is pulled into the anchor hole in the reel. Refer to
Dwg. MHP1366.
3. Wrap the wire rope around the reel one more time, as described in step 2. The wire rope should be
centered in the opening of the housing.
4. Install the wire rope guide.
Installing Ball Stop
1. To install the ball stop, you must have a control package installed.
2. Turn on air to the unit and slowly wind as much wire rope as possible into the unit.
3. Slide ball stop and wire rope stop onto wire rope and up to unit. Swage wire rope stop below ball stop.
The correct clearance between the wire rope guide and ball stop is 3.2 to 6.3 mm (1/8 to 1/4 in.).
Installing Load Chain
1. Rotate reel (see direction of arrow in Dwg. MHP1368) until anchor hole is visible.
2. Attach length of wire to last chain link. Locate the first groove in the reel to the right of the anchor hole.
Insert wire into reel groove and push wire in direction shown in Dwg. MHP1368.
• The weld joint of chain length should be facing away from the reel anchor hole.
3. Remove wire and bolt chain end to reel anchor hole.
CAUTION
NOTICE
(Dwg. MHP1371)
Load Chain Length
Length When New
Chain
Size
mm
5 mm
(3/16 in) 79
Diameter
12
Welded Area
Diameter
(Dwg. MHP0102)
Gauge Length
Discard Length
in mm
3.147 82
Wear in
these
areas
in
3.24