Ypvs Cable Adjustment - Yamaha WaveRunner Gp1200R Wartungshandbuch

INSP
ADJ
CONTROL SYSTEM
NOTE:
If correct adjustment by using the cable
joint at the wheel end is not obtained,
adjust the cable joint on the trim nozzle end.
Refer to "REMOTE CONTROL CABLES AND
SPEED SENSOR LEAD" in chapter 8.

YPVS cable adjustment

1. Check:
YPVS valve position
Incorrect position → Adjust the YPVS
cable.
Checking steps:
Start the engine and then stop it.
NOTE:
When the engine has been stopped for 3
seconds, the YPVS valve assembly will
extend and retract one time.
Check that the hole a in the pulley is
aligned with the hole in the cylinder
when the YPVS valve is fully closed.
2. Measure:
YPVS cable slack a
Out of specification → Adjust.
YPVS cable slack:
0.5 ~ 1.5 mm (0.02 ~ 0.06 in)
3-6
E