bürkert 8026 Kurzanleitung Seite 89

Type 8026 - 8036 - 8076
Réglage et fonctionnalités
• Choisir les unités des totalisateurs
This is This is
when the when the
device is be- device is be-
2
ing parame- ing parame-
tered............ tered............
.................... ....................
Param Display
• Configurer le mode de raccordement des sorties
This is This is
when the when the
device is be- device is be-
3
ing parame- ing parame-
tered............ tered............
.................... ....................
Param Outputs
• Configurer les sorties courant
4
Param Outputs
This is This is
when the when the
device is be- device is be-
ing parame- ing parame-
tered............ tered............
.................... ....................
• Configurer les sorties transistor
5
Param Outputs
This is This is
when the when the
device is be- device is be-
ing parame- ing parame-
tered............ tered............
.................... ....................
Total1/Total2 Unit:
HWMode sinkNPN
sourcePNP
AC1/AC2 PVar:
4mA:
20mA:
Filter:
DiagnosMode:
TR1/TR2 PVar:
Mode:
Low:
High:
Contact:
Delay:
Pulse:
français
• Ajuster les sorties courant
6
Calib Outputs
• Saisir le facteur K ou le déterminer par Teach-in
7
Calib Sensor
AC1/AC2 4mA:
20mA:
K fact.
Vol.Teach PVar:
Start Teach
Flow Teach
PVar:
Start Teach
25