Cleaning And Maintenance; Introduction; Daily Cleaning; Monthly Cleaning - EVA Stampaggi ARIA 50 Bedienungshandbuch

05.1 INTRODUCTION

The stove requires simple yet constant cleaning to guarantee maximum efficiency and proper functioning.
Constant maintenance by a qualified technician is recommended.
The stove should be cleaned before the cold season because it can sometimes get clogged during the summer (by nests for example) preventing
exhaust fumes to flow regularly.
At the beginning of the season and in case of wind, a build-up of residue in the pipe may lead to fires. Should this happen, find below a few
pieces of advice to follow:
•
Block air supply to the pipe immediately;
•
Throw sand or kitchen salt, and not water, to extinguish fire and coals;
•
Keep objects and furniture away from the burning pipe.
ALSO TO PREVENT THIS TYPE OF FAULT YEARLY CLEANING OF THE VENT PIPE IS ESSENTIAL, REMOVING DEPOSITS OR ANY POCKETS OR
OBSTRUCTIONS.
ATTENTION:
•
THE AUGER TUBE MUST BE COMPLETELY EMPTIED FROM PELLETS WHEN USING THE STOVE FOR THE LAST TIME AT THE END OF THE
SEASON. THE AUGER TUBE MUST REMAIN EMPTY TO PREVENT IT FROM BECOMING CLOGGED BY SAWDUST RESIDUES THAT HAVE
SOLIDIFIED DUE TO MOISTURE.
05.2 PERIODIC CLEANING OF THE STOVE

Daily cleaning

This operation must be performed when the stove is completely cold:
•
Aspirate the bottom of the burn pot inside the combustion chamber.
Weekly cleaning
This operation must be performed when the stove is completely cold:
•
Vacuum the combustion chamber: check that there are no embers that
may still be lit. In this case your dust vacuum cleaner will catch fire.
•
Remove the ash inside firebox and on door.
•
Wipe the glass with a damp cloth or a damp ball of newspaper dipped
into the ash. If the operation is performed with the stove hot there is a
risk of the glass exploding.
•
Empty the ash drawer: vacuum it out or dispose of the ashes in a waste
bin.
•
Aspirate the ash drawer compartment and the inspection window
adjacent to the same.

Monthly cleaning

This operation must be performed when the stove is completely cold:
•
Aspirate the T lid of the fume connection. Open the side inspection window and remove the T lid.
ATTENTION: USE A DRY CLOTH TO CLEAN THE STOVE EXTERNALLY. DO NOT USE ABRASIVE MATERIALS OR PRODUCTS THAT MAY CORRODE
OR LIGHTEN THE SURFACES.

05.3 MANUFACTURER LIABILITY

The manufacturer shall not be held liable against any direct and/or indirect, criminal and/or third party liability arising from:
•
failure to abide by the instructions contained herein.
•
non authorised repair operations or changes.
•
use not compliant with safety rules.
•
installation not compliant with national current regulations and safety rules.
•
insufficient maintenance.
•
the use of spare parts that are not original or which are not specific to the stove model.

05. CLEANING AND MAINTENANCE

76