Inhaltsverzeichnis
Werbung
Fan noise coming
from the induction
hob.
Pans do not become
hot and
appears in the
display.
The induction hob or a
cooking zone has
turned itself off
unexpectedly, a tone
sounds and an error
code is displayed
(typically alternating
with one or two digits
in the cooking timer
display).
Failure Display and Inspection
If an abnormality comes up, the induction hob will enter the protective state
automatically and display corresponding protective codes:
Problem
Possible causes
F1-F6
Temperature sensor failure
F9-FA
Temperature sensor of the
IGBT failure.
FC
The connection between the
display board and the main
board has failed.
E1/E2
Abnormal supply voltage
A cooling fan built into your
induction hob has come on to
prevent the electronics from
overheating. It may continue
to
run even after you've turned
the
induction hob off.
The induction hob cannot
detect the pan because it is not
suitable for induction cooking.
The induction hob cannot
detect the pan because it is too
small for the cooking zone or
not properly centred on it.
Technical fault.
This is normal and needs no action.
Do not switch the power to the
induction hob off at the wall while
the fan is running.
Use cookware suitable for induction
cooking. See section 'Choosing the
right cookware'.
Centre the pan and make sure that
its base matches the size of the
cooking zone.
Please note down the error
letters and numbers, switch
the power to the induction hob
off at the wall, and contact a
qualified technician.
What to do
Please contact the supplier.
Please contact the supplier.
Please contact the supplier.
Please inspect whether power
supply is normal.
Power on after the power
supply is normal.
EN-26
Werbung
Inhaltsverzeichnis
