Assembling The Carburetor; Adjusting The Carburetor - Yamaha F6AMH Wartungshandbuch

CARBURETOR

ASSEMBLING THE CARBURETOR

1. Install:
Needle valve 3


Float 1


Float pin 2


NOTE:
When setting the float 1 into the


carburetor body, hook the needle valve 3
into the float 1 and insert the needle
valve seat.
Tap float pin 2 in the direction of arrow a


of carburetor body 4 and with a pin to
install.
After installation,make sure that the float


1 operates smoothly.
2. Measure:
Float hight


Out of specification
Float height
19.0 - 20.0 mm (0.75 - 0.79 in)
NOTE:
Make sure to tilt the carburetor body


clockwise 45° for needle valve with spring
no load, when measuring the float height
b
.
Take measurement at the side end of the


float, as shown.

ADJUSTING THE CARBURETOR

Adjust:
Pilot screw


Refer to "ADJUSTING THE ENGINE
IDLING SPEED" on page 3-10.
4-13
b
Replace.

b
: