Patient Application; Figure 11. Thread And Tighten Wristband - Nonin 3150 Bedienungsanleitung

Patient Application

The WristOx Model 3150, is usually worn on the back of a patient's wrist.
2,
NOTE: The wristband can be used to secure the device to an alternate location (e.g., the
upper arm or a bed rail).
NOTE: Ensure the wristband fits comfortably on the patient's arm. Do not over-tighten the
wrist band.
1. Verify the wristband has been attached properly to the device (figure 9). If the wristband
has not been attached to the device, see "Attaching the Wristband."
2. Place the device on the patient's wrist.
3. Thread the rounded end of the wristband through the plastic ring. Pull the strap through
the plastic ring until the device fits comfortably on the wrist (figure 11).
4. Fold the wristband back over the plastic ring (figure 12) and attach the fastener to the
wristband (figure 13 or figure 14). Wrist circumference will determine which fastener is
used.
NOTE: When using the rectangle fastener, the end of the wristband can be shortened. To
do so, fold the end of the wristband so the square fastener attaches onto the wristband
(figure 13).
20
Figure 11: Thread and Tighten Wristband
Using the WristOx Model 3150
2,