Herunterladen Inhalt Inhalt Diese Seite drucken

Electrical Connection - Hoshizaki KM-520MAJ-E Bedienungsanleitung

Modulare eismaschine für sichelförmige eiswürfel
Vorschau ausblenden Andere Handbücher für KM-520MAJ-E:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 8
3. Location
IMPORTANT
1. This icemaker is not intended for outdoor
use. Normal operating ambient temperature
should be within +7°C to +40°C. Normal
operating water temperature should be
within +7°C to +35°C. Operation of the
icemaker, for extended periods, outside
of these normal temperature ranges may
affect production capacity.
2. The icemaker should not be located next to
ovens, grills or other high heat producing
equipment.
3. The location should provide a firm and level
foundation for the equipment.
4. Allow 15 cm. clearance at rear, sides and
top for proper air circulation and ease of
maintenance and/or service should they be
required.
5. This appliance is not suitable for installation
in an area where a water jet could be used
and where dripping is not allowed.
6. Do not place anything in front of the louver.
7. This icemaker will not work at subfreezing
temperatures. To prevent damage to the
water supply line, drain the icemaker when
air temperature is below zero.
4. Installation
• The installation must be carried out by qualified
personnel, in accordance with current regulations,
according to the manufacturer's instruction.
• Incorrect installation can cause harm to people,
animals, the icemaker, or the installation location, for
which the manufacturer cannot be held responsible.
1) Unpack the storage bin, and attach the four
adjustable legs provided (bin accessory) to the
bottom of the storage bin.
2) Position the storage bin in the selected permanent
position.
3) Place the icemaker onto the top of the storage
bin taking care not to damage the bin top sealing
gasket.
4) From the accessory pack, locate the two universal
braces and bolts to secure the icemaker to the bin.
See Fig. 2.
Icemaker
Ice Storage Bin
(B-300 Series)
5) Level the icemaker/storage bin in both the
left-to-right and front-to-rear directions by turning
the bin leg adjusters with a wrench.
6) Make sure the bin control thumbscrews are tight.
7) Replace the panels in their correct positions.

5. Electrical Connection

THIS APPLIANCE MUST BE EARTHED
This icemaker requires an earth that meets
the national and local electrical code
requirements. To prevent possible severe
electrical shock to individuals or extensive
damage to equipment, install a proper earth
wire to the icemaker. Turn off the power supply
before any maintenance, repairs or cleaning is
undertaken.
• This icemaker must have a separate power supply or
receptacle of proper capacity. See the nameplate. It is
recommended that this icemaker be the only electrical
device on its power supply circuit.
• Usually an electrical permit and services of a licensed
electrician are required.
• If a power cord and/or a plug should need to be fitted/
replaced, it should only be done by a qualified service
engineer.
• Factory fitted power cords are coloured in accordance
with the following code:
Green & Yellow = Earth
Blue = Neutral
Brown = Live
3
Universal
Braces
Bolts
Fig. 2
WARNING

Werbung

Inhaltsverzeichnis
loading

Diese Anleitung auch für:

Km-660maj-e

Inhaltsverzeichnis