Installation
WARNING! RISK OF FIRE!
►
Never place the appliance beneath wall
cabinets or adjacent to curtains, wall units
or other flammable objects .
►
A minimum clearance of 10 cm must be
maintained between the appliance and wall
cupboards, ceilings, walls or similar structures,
measured upwards of the appliance, and
5 cm measured laterally . For this reason the
appliance may not be used, for example, in
cupboards or similar . Otherwise there is likely
to be insufficient ventilation for the appliance,
which could result in fire or damage .
►
Always place the appliance on a heat-resist-
ant surface . Failure to do so increases the risk
of fire or of the appliance being damaged .
The surface under appliance may become
discoloured and be damaged . Additionally,
permanent indentations could arise if the
appliance is placed on a soft surface .
DANGER – ELECTRIC SHOCK!
►
Do not place the appliance immediately adja-
cent to sources of water, e .g . sinks or basins,
or in damp cellar areas . Otherwise, there is a
risk of receiving an electric shock .
■
Place the appliance on a solid, level and heat-
resistant surface (e .g . stainless steel worktops
or natural stone worktops such as granite) .
Ensure there is sufficient ventilation around the
appliance .
■
Push the appliance up against the wall, with its
rear side facing the wall . The spacers on the
back must touch the wall . Ensure that the wall is
made of heat-resistant material, e .g . tiles, natural
stone or granite .
■
Clean all components as described in the section
"Cleaning and care" .
■
54
│
GB │ MT
Using the appliance
Glass door
CAUTION! PROPERTY DAMAGE!
►
Do not lean on the glass door . Do not place
objects on the glass door . This can cause
damage to the door hinges .
■
Cooking some foods, especially fatty foods,
can result in increased smoke production . In this
case, do not close the glass door completely;
instead, leave it slightly open .
The glass door has a latching position so that
it remains open a little: if you carefully push
the glass door closed, it clicks into this position
shortly before closing completely .
Inserting the crumb tray
■
Push the crumb tray 7 under the lower heating
element so that it rests flat on the bottom of the
appliance .
Using the rack
WARNING! RISK OF INJURY!
►
Always use the tongs 0 to insert the rack 8
into the appliance or to remove it .
■
Push the rack 8 onto one of the 2 rails 1 in the
cooking chamber of the appliance .
CAUTION! MATERIAL DAMAGE!
►
Never place the rack 8 directly upon the
heating elements .
SGB 1200 A4